MOA=DISABLED, CCMODE=COMPARE, ICEDGE=RISING, INSEL=PRS, OFSEL=PRECNT, OFOA=DISABLED, PRSCONF=PULSE
No Description
| ENABLE | Channel Enable |
| CCMODE | Compare/Capture mode 0 (COMPARE): Compare mode selected 1 (CAPTURE): Capture mode selected |
| PREMATCHEN | Enable PRECNT matching |
| BASEMATCHEN | Enable BASECNT matching |
| WRAPMATCHEN | Enable WRAPCNT matching |
| OIST | Output Initial State |
| OUTINV | Output Invert |
| MOA | Match Output Action 0 (DISABLED): No action on compare match 1 (TOGGLE): Toggle output on compare match in COMPARE mode. 2 (CLEAR): Clear output on compare match in COMPARE mode. 3 (SET): Set output on compare match in COMPARE mode. |
| OFOA | Overflow Output Action 0 (DISABLED): No action 1 (TOGGLE): Toggle output when the selected counter has an overflow event. 2 (CLEAR): Clear output when the selected counter has an overflow event. 3 (SET): Set output when the selected counter has an overflow event. |
| OFSEL | Select counter for OFOA bits 0 (PRECNT): Use PRECNT overflow 1 (BASECNT): Use BASECNT overflow 2 (WRAPCNT): Use WRAPCNT overflow 3 (DISABLED): Disabled |
| PRSCONF | PRS Configuration 0 (PULSE): Each CC event will generate a one HFRADIOCLK cycle high pulse 1 (LEVEL): Should be used when OFSEL, OFOA or MOA are specified. |
| INSEL | Capture input selection 0 (PRS): Use the selected PRS channel 1 (TXDONE): TX completed 2 (RXDONE): RX completed 3 (TXORRXDONE): TX or RX completed 4 (FRAMEDET0): Demodulator found sync word 0 5 (FRAMEDET1): Demodulator found sync word 1 6 (FDET0OR1): Demodulator found sync word 0 or 1 7 (MODSYNCSENT): Modulator sync word sent 8 (RXEOF): RX at end of frame from demodulator 9 (PRORTC0): PRORTC capture/compare 0 10 (PRORTC1): PRORTC capture/compare 1 |
| ICEDGE | Input Capture Edge Select 0 (RISING): Rising edges detected 1 (FALLING): Falling edges detected 2 (BOTH): Both edges detected 3 (DISABLED): No edge detection, signal is left as it is |